Request a quote

Getting 1960s armrests right

Open the door of an unrestored classic and look at the armrest. If it's original, it's probably cracked, hardened, or crumbling under the vinyl. That is not neglect, it is chemistry, and it's why restoration foam is a molding problem, not an upholstery problem.

Why the originals die

Factory armrests and interior parts from the 1950s through the mid-1970s were molded foam, and the formulations of that era break down with decades of heat cycles and UV. Once the foam goes, no amount of re-covering saves the part, because the shape itself is gone.

Why you can't just carve a replacement

An original armrest was an integral skin molded part: the foam and its tough outer skin formed together in the mold, often with the mounting hardware embedded. Cutting a lookalike from sheet foam gets the silhouette and loses everything else: the crisp factory edges, the skin that takes vinyl properly, and the hardware in the right place. Doing it right means doing it the way the factory did, in a mold.

What replication involves

Tooling built from an original part, a formulation matched to the factory feel, and molding that reproduces the details a judge, or your own hand on the door, will notice. H&D replicates integral skinned foam parts to original quality for vehicles from 1950 onward, and many of those parts reach owners through restoration-parts sellers.

If your part doesn't exist anymore

Not every armrest, steering wheel insert or seat foam is in someone's catalog. If you have one restorable original, even a rough one, it can serve as the basis for tooling. That is a conversation worth having before you settle for close enough.

Restoring an original part?

Send photos of the part, even rough ones. If it can be replicated, the team will tell you how.

Request a quote